Bobcat Mt52 Mt55 Compact Track Loader Service Repair Manual
Complete workshop repair & service manual with electrical wiring diagrams for Bobcat MT52, MT55 Mini Track Loader. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
The tool listed will be needed to do the following
procedure:
MEL10630 – Engine Compression Test Kit Warm the engine.
Remove the glow plugs, muffler and air cleaner from the
engine. (If testing through glow plug hole.)
Remove the air cleaner, muffler and all injector nozzles.
(If testing through injector nozzle hole.)
Install a compression adapter from the kit (that closely
resembles either the glow plug or injector, depending on
where you are taking the test reading) in the cylinder
head.
Connect the compression gauge to the adapter [Figure
70-10-16].
Ensure the speed control lever is set at the low idle
setting.
Hold fuel shut off lever to no fuel. (shut-off) See arrow,
[Figure 70-10-16]. Shut off solenoid does not need to be
removed.
Turn the engine with the starter at 200 – 300 rpm. Run the
test for each cylinder more than twice for 5 – 10 seconds
each time and take the average reading. Make sure you
are using a fully charged battery for each and every run.
Bobcat Mt52 Mt55 Compact Track Loader Service Repair Manual
This Bobcat MT52, MT55 Mini Track Loader service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
6902524 (10-04) – MT52 Operation & Maintenance Manual.pdf
6902525 (3-06) – MT52 Service Manual.pdf
6903371 (5-07) – MT55 Mini Loader Operation & Maintenance Manual.pdf
6903372 (5-07) – MT52, MT55 Service Manual.pdf
6903375 (5-07) – MT52 Mini Loader Operation & Maintenance Manual.pdf
6986856 (8-10) – MT52 Mini Loader Operation & Maintenance Manual.pdf
6986858 (3-10) – MT55 Mini Loader Operation & Maintenance Manual.pdf
6986859 (3-11) – MT52, MT55 Mini Track Loader Service Manual.pdf
6986859 (9-10) – MT52, MT55 Mini Track Loader Service Manual.pdf
EXCERPT:
CONTENTS
SAFETY & MAINTENANCE
HYDRAULIC SYSTEM
HYDROSTATIC SYSTEM
DRIVE SYSTEM
MAINFRAME
ELECTRICAL SYSTEM & ANALYSIS
ENGINE SERVICE
SPECIFICATIONS
ALPHABETICAL INDEX
…
ENGINE INFORMATION (CONT’D)
Removal And Installation (Cont’d)
Figure 70-10-11
Remove the two side mounting bolts and nuts (Item 1) [Figure 70-10-11] from each side of the loader.
Figure 70-10-12
Remove the rear mounting bolt (Item 1) [Figure 70-10-12] from the loader.
Lift the engine out of the loader.
Reverse the removal procedure to install the engine.
Once the engine is placed back in the loader, check the drive belt alignment of the flywheel pulley, belt tensioner and the hydrostatic pump pulleys. Adjustments can be made to align the drive belt properly. For more information on drive belt alignment: (See Alignment on Page 30-50-2.)
